User Tools

Site Tools


Navigation Menu

Rustic Retreat

Live broadcasts and documentation from a remote tech outpost in rustic Portugal. Sharing off-grid life, the necessary research & development and the pursuit of life, without centralized infrastructure.

Rustic RetreatSubscribe to our new main project Rustic Retreat on the projects own website.

Hot Projects

SEEDStack

SEEDStack - Open 3D printable seed/sprouting systemDIY Food Hacking

UCSSPM

UCSSPM - Unified Clear-Sky Solar Prediction ModelOpen Solar Power

picoReflow

picoReflow - DIY PID Reflow Oven Controller based on RaspberryPiDIY Reflow Soldering

PiGI

PiGI - DIY Geiger Counter based on RaspberryPiRasPi Geiger Counter

DIY ARA-2000

Active Wideband Receiver Antenna for SDR - ARA-2000Wideband Antenna

DSpace

DSPace - Map everythingMap everything!

Mission-Tags

Cable Management?

At long last the Felix 3.0B upgrade parts have finally arrived last week and the picoprint underwent a complete overhaul. On Friday night the printer was completely disassembled, except for the bare frame.

All printed plastic parts (V2.0) were packed away (as a backup for now) and all screws, nuts and other metallic parts took a bath in WD-40 for 24 hours and were cleaned, re-sorted and stored in the original container. Having only sunday left, the assembly of the 3.0B went up to the part of implementing proper cable management.

Cable Management

This shot gives a good impression of the amount of cables to route and this is only the bare Felix configuration without any other extras. The next long weekend is directly ahead, so the printer should be fully upgraded, re-pimped and ready to print on the weekend.

About time, I miss the smell of extruded PLA in the morning…