Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| mission:resources:picoreflow [2016-10-09 12:03] – [Heating] chrono | mission:resources:picoreflow [2016-10-27 22:33] (current) – [Heating] chrono | ||
|---|---|---|---|
| Line 100: | Line 100: | ||
| + | The default configuration has historically been to use the PullDown config, which results in an inverted control logic: When you pull GPIO23 low, the heater is switched on and when you pull GPIO23 high, the heater is switched off. | ||
| + | |||
| + | <WRAP round important> | ||
| + | **Please keep in mind that you'll have to have some script/code in your setup that makes sure that GPIO23 is pulled high as soon as the system has booted** (to be sure the heater is off) or change your setup to PullUp configuration instead, if you don't want to worry/ | ||
| + | </ | ||
| ==== Cooling ==== | ==== Cooling ==== | ||
| Line 285: | Line 290: | ||
| A custom built oven to bake carbon composite parts. | A custom built oven to bake carbon composite parts. | ||
| + | |||
| + | ==== WiFi/ | ||
| + | |||
| + | {{: | ||
| + | |||
| + | http:// | ||
| + | |||
| {{tag> | {{tag> | ||